Decoupage Napkins in a Faux Galvanized Tin Holder

Here are the steps I took to create the coasters:

1. I purchased these stone tiles as part of a package at Home Depot. I cleaned the them thoroughly.

2. I usually paint the tops and sides with our Missouri Limestone Paint Company chalk-style paint in “January” as white paint will really help the print stand out. But these coasters were already white on one side so I skipped this step.

3. I chose areas of the napkin that would look good centered on the tiles and cut them a little bigger than the coaster. I peeled off the two white layers of the napkin so that I was left with only the printed part. Sometimes napkins will only have one white layer.

4. For the decoupage medium, I used Mod Podge on this set. I applied a layer over the white paint and while still wet I applied the napkin. I used a piece of plastic wrap to press the napkin into the stone, making sure I had no bubbles.this plastic wrap helps to keep the napkin from sticking to my fingers.

5. Once dry, I used 220 sandpaper to sand the edges.

6. I then used 2 coats of Rustoleum spray lacquer on the tops and sides to seal the napkin. Using lacquer will not reactivate the poly, so no bubbles formed.

I used a painting technique to create a faux galvanized tin look to a plain black coaster holder.

You can see how I did this technique in another blog post, found here.

I enjoyed doing this technique so much I have used it on a variety of items.